В теме одно сообщение

[getAway]

Kia Sportage SL (2010+) - замена сцепления

Removal 1. Remove the transaxle assembly. (Refer to "Manual transaxle system" in MT group) 2. Remove the clutch cover bolts. Be careful not to be bent or twist bolts. Loosen bolts in diagonal directions.  Kia Sportage SL (2010+) - замена сцепления.jpg   52.42К   7 Количество загрузок:

[getAway]

Installation
Self Adjusting Clutch (S.A.C.) Cover

•
If reinstalling used cover, the cover should be installed with its clutch disc as a set.
•
When replacing only a disc, a slip problem can occur because of the load loss due to uneven surface wear.
•
When replacing only a disc, it can be difficult to cut power because the thickness of the disc won't permit it.
1.
Apply grease on a disc spline part and transmission input shaft spline part as required.

Possible problems when not following
•
When not applying: Excessive wear of splines and bad clutch operation can occur.
•
When excessively applying: Grease can be scattered bycentrifugal force which can conteminate the clutch disc. This can cause a loss of friction force causing a slip.

 Kia Sportage SL 2010 - замена сцепления (1).jpg   26.51К   6 Количество загрузок:
2.
The 'T/M SIDE' marked surface should face transmission.

Possible problems when the disc is installed in the opposite direction.
•
There can be an interference between the concentric slave cylinder on the TM side and a engine flywheel surface.
•
Transaxle shift errror or a strangesound can occur due to clutch separation.
•
The concentric slave cylinder can break. If it does, the concentric slave cylinder should be replaced new one.

 Kia Sportage SL 2010 - замена сцепления (2).jpg   24.54К   7 Количество загрузок:
3.
Install the clutch disc and the cover with SST (09411-1P000).

 Kia Sportage SL 2010 - замена сцепления (3).jpg   61.95К   7 Количество загрузок:
4.
Install the clutch cover bolts. Not to be bent or twisted, Tighten them in diagonal directions.
Tightening torque:
Diesel 2.0: 24.5 ~ 35.3 N.m (2.5 ~ 3.6 kgf.m, 18.1 ~ 26.0 lb-ft)
Diesel 1.7: 11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)
Gasoline 1.6: 14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m, 10.8 ~ 15.9 lb-ft)

•
Loosely tighten every clutch cover bolts, then torque to specifications in a diagonal direction. This can prevent twisting, vibration of the cover, and the lifting of the pressure plate.
•
Install the all the components with the specified torques. If not, the clutch torque transmission may have concerns or the mounting bolt can loosen.

 Kia Sportage SL 2010 - замена сцепления (4).jpg   63.16К   7 Количество загрузок:
5.
Install the transaxle assembly.