Личный гаражKia Magentis MS (2001-2006) - замена сцепления
REMOVAL
1.
To remove the transaxle assembly firstly remove the air cleaner joint, mounting bracket, and wiring etc.
2.
Remove the release lever.
Kia Magentis MS 2001-2006 - замена сцепления (1).jpg 22.7К
10 Количество загрузок:
(1)
Loosen the release lever nut and washer.
(2)
Remove the clevis pin and snap ring from the release cylinder.
(3)
Remove the release lever.
It is impossible to remove transaxle assembly without doing this step. Because, clutch cover, release bearing and release fork are combined together.
3.
Loosen the bolts attached to the release cylinder and remove the release cylinder.
4.
Remove the transaxle assembly, after removing each bolt which connect the transaxle assembly and engine.
Kia Magentis MS 2001-2006 - замена сцепления (2).jpg 17.36К
9 Количество загрузок:
5.
In the state that the clutch cover is attached to the flywheel remove the release bearing using appropriate tool as shown.
(1)
Rotate the release bearing in the easy direction in order to examine the snap ring.
(2)
Insert the tool under the wave washer as shown in the illustration and locate in the center of snap ring.
(3)
Widen the space of snap ring by pushing the bearing an shown in the illustration.
Kia Magentis MS 2001-2006 - замена сцепления (3).jpg 29.19К
11 Количество загрузок:
(4)
The snap ring-widen state is like as shown the figure.
Kia Magentis MS 2001-2006 - замена сцепления (4).jpg 27.79К
9 Количество загрузок:
(5)
In the snap ring-widen state pull out the release bearing and remove it.
6.
Insert the special tool (09411-11000) in the clutch disc to prevent the disc from falling.
7.
Loosen the bolts which attach the clutch cover to the flywheel in a star pattern. Loosen the bolts in succession, one or two turns at a time, to avoid bending the cover flange.
Do not clean the clutch disc or release bearing with cleaning solvent.
8.
Remove the release fork shaft and bushing.
Kia Magentis MS 2001-2006 - замена сцепления (5).jpg 29.19К
8 Количество загрузок:
