Kia Cerato TD (2009+) - снятие и установка радиатора кондиционера
Replacement Condenser Assembly 1. Recover the refrigerant with a recovery/ recycling/ charging station . 2. Disconnect the negative (-) battery terminal. 3. Remove the front bumper. (Refer to BD group - "Front Bumper") 4. Disconnect the refrigerant line (A). 1 copy.jpg 33.79К 8 Количество загрузок: 5. Remove the radiator assembly. (Refer to EN group - "Radiator") 6. Remove the condenser (A) by lifting it up. Be careful not to damage the radiator and condenser fins when removing the condenser. 2 copy.jpg 34.15К 11 Количество загрузок: 7. Install in the reverse order of removal, and note these items : A. If you're installing a new condenser, add refrigerant oil ND-OIL8. B. Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage. C. Be careful not to damage the radiator and condenser fins when installing the condenser. D. Be sure to install the lower mount cushions of condenser securely into the holes. E. Charge the system, and test its performance. Desiccant Replacement 1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser. 3 copy.jpg 22.75К 10 Количество загрузок: TORQUE : 20~25N.m (2.0~2.5kgf•m, 14.5~18.2lb-ft) 2. Remove the desiccant (A) from condenser using a long nose plier. Check for crumbled desiccant and clogged bottom cap filter. 4 copy.jpg 22.28К 8 Количество загрузок: 3. Apply air conditioning compressor oil along the O-rings and threads of the new bottom cap. 4. Insert the new desiccant into the receiver drier tank. The desiccant must be sealed in vacuum before it is exposed to air for use. 5. Install the new bottom cap to the condenser. - Always replace the desiccant and bottom cap at the same time. - Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage. - Be careful not to damage the radiator and condenser fins when installing the condenser. - Be sure to install the lower mount cushions of condenser securely into the holes. - Charge the system, and test its performance.