Перейти к содержимому

Киа Форум клуб©


Фотография
Киа Карнивал 2 VQ

сцепление



  • Вы не можете создать новую тему
  • Авторизуйтесь для ответа в теме
В теме одно сообщение

#1 getAway

getAway

    На личные сообщения не отвечаю

  • Живая легенда
  • 3839 сообщений
    Доп. инфо + Доп. инфо -
Гараж Личный гараж

Отправлено 02 November 2012 - 15:20

Kia Carnival VQ (2006-2010) - замена сцепления REPLACEMENT 1. Remove a transaxle assembly (refer to 'MT'-group). 2. Remove the clutch cover bolts. Not to be bent or twisted, loosen them in diagonal directions. Прикрепленный файл  Kia Carnival VQ 2006-2010 - замена сцепления (1).jpg   52.71К   12 Количество загрузок: 3. Remove the clutch cover and disc. 4. Using the SST(09411-43000), install a clutch disc and cover. • Replace a clutch cover and disc as a set. * Possible problems when not following the caution - When replacing only a disc, slip problem can occur because of the initial clamp load loss by the adjusting ring's unusual work. - When replacing only a disc, it can be difficult to cut power because the thickness of the disc cannot be permitted. • Apply grease on a disc spline part and transmission input shaft spline part as required. * Possible problems when not following - When not applying: Excessively wear of splines and bad clutch operation - When excessively applying: Scattered grease by centrifugal force conteminates the clutch disc. Loss of friction force can cause a slip • The 'T/M SIDE' marked surface should face the transaxle. ? If the surface face the opposite side, there can be an interference between a disc and a flywheel surface. Прикрепленный файл  Kia Carnival VQ 2006-2010 - замена сцепления (2).jpg   19.15К   9 Количество загрузок: 5. Tighten the clutch cover. TORQUE: 24.5~35.3Nm (250~360kgf.cm, 18.1~26.0lb-ft) (6EA) When installing the clutch cover, tighten the bolts in diagonal directions not to be bent or twisted. Прикрепленный файл  Kia Carnival VQ 2006-2010 - замена сцепления (3).jpg   39.07К   10 Количество загрузок: * Possible problems when not following - When tightening the bolt completely at a time: the clutch cover can be twisted and vibration can occur. - On vehicles with self adjusting clutches, it is necessary to follow this caution. - Not following tightening torque: There can be bad torque transmission in clutch and relaxation possibility of bolts.


Центр кузовного ремонта в Москве: kuzovnoi.center

Все, кто хочет получить скидку на ремонт - пишут в личку KRIONIKe


#2 krionika Re: сцепление

krionika

    Я - Легенда!

  • Администраторы
  • 23941 сообщений
    Доп. инфо + Доп. инфо -
Гараж Личный гараж

Отправлено 14 March 2007 - 16:17

Прикрепленный файл  Сцепление Киа Карнивал VQ.gif   9.51К   0 Количество загрузок:

Скрытый текст





Последние обсуждения по киа карнивал 2 vq на MyKia.club

Яндекс.Метрика Top.Mail.Ru Запрещено любое копирование материалов сайта без согласия администрации. Copyright © 2024 mykia.club