Kia Carnival GQ (1998-2006) - замена шруса
Removal Drain transaxle oil before disassembly. 1. Raise vehicle and support it with safety stand. 2. Loosen and remove four wheel nuts. 3. Remove wheel and tire. 4. Loosen and remove control link nut and disconnect stabilizer bar from control link on lower control arm. Do not damage dust boot. 5. Loosen and remove tie rod nut and disconnect tie rod end with SST(0K130 283 021). Do not damage dust cover or oil seal. Kia Carnival GQ 1998-2006 - замена шруса (1).jpg 30.97К 10 Количество загрузок: 6. Remove the lower arm ball joint bolt and nut from the steering knuckle. Kia Carnival GQ 1998-2006 - замена шруса (2).jpg 24.92К 11 Количество загрузок: Use caution when seperating lower arm from steering knuckle, so ball joint seal does not get cut. 7. Using a pry bar, seperating steering knuckle from lower arm. Kia Carnival GQ 1998-2006 - замена шруса (3).jpg 33.91К 7 Количество загрузок: 8. Use a pry bar to seperate the front wheel driveshaft from the transaxle. • Seperate the front wheel driveshaft from transaxle gradually. If it is suddenly yanked out of transaxle, the differential oil seal may be damaged. • Plug the transaxle case opening with oil seal cap in order to avoid contamination. Kia Carnival GQ 1998-2006 - замена шруса (4).jpg 34.63К 7 Количество загрузок: 9. Remove driveshaft from front hub. If driveshaft is frozen in front wheel hub, spray a penetrating solvent into splined area and then reinstall lock nut so that it is flush with end of shaft.Tap nut with a brass hammer to remove driveshaft. Take care not to damage the inner wheel bearing oil seal while removing the front wheel driveshaft from the front wheel hub. Kia Carnival GQ 1998-2006 - замена шруса (5).jpg 30.04К 7 Количество загрузок: 10. Separate right-side dirveshaft from joint shaft by hammering on a brass pry bar inserted between them. 11. Loosen and remove three joint shaft bolts and pull joint shaft straight out.