В теме одно сообщение

[getAway]

Kia Sportage KM (2005-2010) - замена сцепления

REPLACEMENT 1. Remove the transaxle assembly.(See 'TR' group - 'Manual Transaxle') 2. Insert the special tool (09411-11000) in the clutch disc to prevent the disc from falling.  Kia Sportage KM 2005-2010 - замена сцепления (1).jpg   39.66К   10 Количество загрузок: 3. Loosen the bolts which attach the clutch cover to the flywheel in a star pattern. Loosen the bolts in succession, one or two turns at a time, to avoid bending the cover flange. Do not clean the clutch disc or the release bearing with cleaning solvent.  Kia Sportage KM 2005-2010 - замена сцепления (2).jpg   42.09К   7 Количество загрузок: 4. Remove the release fork shaft and bushing. 5. Apply multipurpose grease to the spline of the disc. Grease: CASMOLY L 9508 0.2gr When installing the clutch, apply grease to each part, but be careful not to apply excessive grease. It can cause clutch slippage and judder.  Kia Sportage KM 2005-2010 - замена сцепления (3).jpg   52.97К   8 Количество загрузок:

[getAway]

6.
Install the clutch disc assembly to the flywheel using the special tool (09411-11000).
7.
Install the clutch cover assembly to the flywheel and temporarily tighten the bolts one or two steps at a time in a star pattern.
Tightening torque
Clutch cover bolt:
15 ~ 22 Nm (150~220 kgf·cm, 11~16 lbf·ft)

 Kia Sportage KM 2005-2010 - замена сцепления (4).jpg   36.91К   8 Количество загрузок:
8.
Align the bearing (A) to the release fork (B) and then install it to the sleeve of the housing.

Apply multipurpose grease (CASMOLY L9508) to the bearing sleeve, contact point of the release fork (B) and the bushing inner surface ©.

 Kia Sportage KM 2005-2010 - замена сцепления (5).jpg   32.74К   7 Количество загрузок:
9.
Install the release lever to the release fork.

 Kia Sportage KM 2005-2010 - замена сцепления (6).jpg   26.88К   7 Количество загрузок:
10.
Install the transaxle assembly to the engine.

If the transaxle assembly is installed to the engine without performing this step, the release bearing can be separated, as the release fork rotates freely.