В теме одно сообщение

[getAway]

Kia Magentis MG (2006-2011) - замена сцепления Removal 1. Remove the transaxle assembly.(See 'MT' group - 'Manual Transaxle') 2. Remove the release bearing. 3. Remove the clutch cover and the disk from the engine. • Insert the special tool (09411-11000) into the spline hole to support the clutch disk when removing the clutch cover. • Do not use solvent to clean the clutch disk and the release bearing. 4. Remove the bushing and the release fork assembly.

[getAway]

Installation
1.
Grease where is 10mm from the end of the transaxle's input shaft, before installing the clutch disk and cover assembly.
Grease: CASMOLY L9508

 Kia Magentis MG 2006-2011 - замена сцепления (1).jpg   39.68К   9 Количество загрузок:
2.
Install the clutch disc assembly to the flywheel using the special tool (09411-11000).
3.
Install the clutch cover assembly to the flywheel and temporarily tighten the bolts one or two steps at a time in a star pattern.
Tightening torque :
Clutch cover bolt:
25~36 Nm(2.5~3.6 kgf.m, 18~26 lb-ft)

 Kia Magentis MG 2006-2011 - замена сцепления (2).jpg   32.61К   10 Количество загрузок:
4.
Align the bearing (A) to the release fork (B) and then install it to the sleeve of the housing.

Apply multipurpose grease (CASMOLY L9508) to the bearing sleeve, contact point of the release fork (B) and the bushing inner surface ©.
Groove of bearing sleeve : 0.5~1.0g
Contacting part of release fork : 0.3~0.5g
Bushing's neck : 0.8~1.2g

 Kia Magentis MG 2006-2011 - замена сцепления (3).jpg   36.15К   9 Количество загрузок:
5.
Install the release lever to the release fork.

 Kia Magentis MG 2006-2011 - замена сцепления (4).jpg   26.88К   10 Количество загрузок:
6.
Install the transaxle assembly to the engine.

If the transaxle assembly is installed to the engine without performing this step, the release bearing can be separated, as the release fork rotates freely.