Перейти к содержимому

Киа Форум клуб©


Фотография
Киа Карнивал 2 VQ

кондиционер



  • Вы не можете создать новую тему
  • Авторизуйтесь для ответа в теме
В теме одно сообщение

#1 getAway

getAway

    На личные сообщения не отвечаю

  • Живая легенда
  • 3839 сообщений
    Доп. инфо + Доп. инфо -
Гараж Личный гараж

Отправлено 10 October 2012 - 16:32

Kia Carnival VQ (2006-2010) - снятие и установка радиатора кондиционера

REPLACEMENT CONDENSER ASSEMBLY 1. Recover the refrigerant with a recovery/ recycling/ charging station (Refer to HA-8). 2. Disconnect the negative (-) battery terminal. 3. Remove the radiator. (Refer to EM group) 4. Remove 2 bolts, and then remove the condenser (A) by lifting it up. Be careful not to damage the radiator and condenser fins when removing the condenser. Прикрепленный файл  1 copy.jpg   47.85К   9 Количество загрузок: 5. Install in the reverse order of removal, and note these items : A. If you're installing a new condenser, add refrigerant oil ND-OIL8. B. Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage. C. Be careful not to damage the radiator and condenser fins when installing the condenser. D. Be sure to install the lower mount cushions of condenser securely into the holes. E. Charge the system, and test its performance. (Refer to HA-9) DESICCANT 1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser. TORQUE: 20~25N.m (2.0~2.5kgf•m, 14.5~18.2lb-ft) Прикрепленный файл  2 copy.jpg   22.74К   10 Количество загрузок: 2. Remove the desiccant (A) from condenser using a long nose plier. Check for crumbled desiccant and clogged bottom cap filter. Прикрепленный файл  3 copy.jpg   22.28К   9 Количество загрузок: 3. Apply air conditioning compressor oil along the O-rings and threads of the new bottom cap. 4. Insert the new desiccant into the receiver drier tank. The desiccant must be sealed in vacuum before it is exposed to air for use. 5. Install the new bottom cap to the condenser. - Always replace the desiccant and bottom cap at the same time. - Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage. - Be careful not to damage the radiator and condenser fins when installing the condenser. - Be sure to install the lower mount cushions of condenser securely into the holes. - Charge the system, and test its performance. (Refer to HA-10)


Центр кузовного ремонта в Москве: kuzovnoi.center

Все, кто хочет получить скидку на ремонт - пишут в личку KRIONIKe


#2 getAway Re: кондиционер

getAway

    На личные сообщения не отвечаю

  • Живая легенда
  • 3839 сообщений
    Доп. инфо + Доп. инфо -
Гараж Личный гараж

Отправлено 18 October 2012 - 16:48

Kia Carnival VQ (2006-2010) - снятие и установка компрессора кондиционера

REMOVAL 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. 3. Recover the refrigerant with a recovery/charging station (Refer to HA-8). 4. Loosen the drive belt (Refer to HA-14). 5. Remove the bolts, then disconnect the suction line (A) and discharge line (B) from the compressor. Plug © or cap the lines immediately after disconnecting them to avoid moisture and dust contamination. Прикрепленный файл  1 copy.jpg   33.96К   8 Количество загрузок: 6. Disconnect the compressor clutch connector (A), and then remove 4 mounting bolts and the compressor. Прикрепленный файл  2 copy.jpg   55.93К   7 Количество загрузок:


Центр кузовного ремонта в Москве: kuzovnoi.center

Все, кто хочет получить скидку на ремонт - пишут в личку KRIONIKe




Последние обсуждения по киа карнивал 2 vq на MyKia.club

Яндекс.Метрика Top.Mail.Ru Запрещено любое копирование материалов сайта без согласия администрации. Copyright © 2024 mykia.club